Guides / Explainers
Explainer4 min read

What is a black start, and how long does it take?

Almost every power plant needs electricity to start, which is a problem when there is none. This is how a grid gets out of that hole.

The Blackstart Supply power mark on a dark background
The short version
  • A black start restarts a dead grid from a few plants that can start with no outside power, then rebuilds the system one small island at a time.
  • Spain and Portugal needed up to 16 hours in April 2025. The Texas grid operator says a full black start there could take multiple days to weeks.
  • Power returns in blocks and can drop again, so a household plan should cover a day or two with no grid power and unreliable phones.

A black start is what a power company does when the whole grid is dead and has to be brought back from nothing. This company is named after it, so I should explain it properly.

The short answer: almost every power plant needs electricity to start. When an entire region goes dark, there is no electricity to give them. A black start is the procedure for getting around that problem, and it is slower and more fragile than most people assume.

Why can’t a power plant just turn back on?

A large power plant is a building full of pumps, fans, valves and control computers, and all of them run on electricity. In normal life the plant draws that power from the same grid it feeds. Take the grid away and the plant is a car with a dead battery (in a parking lot where every other battery is dead too).

So grid operators keep a small number of plants that can start on their own. The industry calls them black start resources. The US Department of Energy describes the capability as starting a generator from a fully de-energized state. Hydroelectric dams are the classic choice. Other plants keep a smaller generator on site, often a diesel, whose only job is to get the big one turning.

These plants are chosen in advance and tested. In Texas, the grid operator ERCOT selects them every three years, picks them partly for how close they sit to cities and nuclear plants, and can test them without warning.

How does a black start work, step by step?

ERCOT publishes its sequence, and it is roughly the same everywhere:

  1. Start a black start resource.
  2. Use its power to start a second, nearby generator that could not start alone.
  3. Energize the transmission lines around those two plants. This small working patch of grid is called an island.
  4. Add customers back a block at a time, so that demand matches what the generators are making.
  5. Restore the most critical loads first.
  6. Connect the islands to each other until the whole system is back.

Several islands are built in different places at once. Each one has to stay in balance second by second, because a generator with too much or too little load will shut itself off again.

That is the fragile part. A mistake at step four can send you back to step one.

How long does a black start take?

It depends on how much of the grid went down, and on whether the grid next door is still working.

Spain and Portugal are the best recent example. At 12:33 p.m. on April 28, 2025, the Iberian grid collapsed in under 90 seconds, and more than 50 million people lost power. According to POWER Magazine’s account of the final investigation, operators rebuilt it two ways at once: black starts from inside, and power fed in from France and Morocco from outside. Several of the black start attempts failed and had to be tried again.

Portugal’s grid was back at 12:22 a.m. on April 29. Spain’s transmission system followed at about 4:00 a.m. Some regions had waited 16 hours.

That is a good outcome. Iberia had working neighbors to lean on.

Texas is the other case. Its grid is run almost as an island, with few ties to the rest of the country. In February 2021, during a winter storm, the head of ERCOT said the system had been “seconds and minutes” from a collapse that would have forced a black start. He said the blackout that followed could have lasted months.

ERCOT’s own published estimate is calmer. It says a full black start of its region “could take multiple days to weeks.”

Days to weeks is the calm version.

Is it as bad as it sounds?

I do not think so, and I want to be straight about why.

A full black start of a large grid is rare. Most blackouts are local, and power comes back by reconnecting to a neighbor that never went down. Operators drill for the worst case, the plants are tested, and in Iberia the plan worked: a collapse that took 90 seconds was undone in 16 hours.

What bothers me is how thin the margin is. The whole recovery depends on a short list of plants starting when asked, on fuel reaching them, and on people balancing small islands of power by hand while tens of millions of customers wait. ERCOT runs a separate working group just to make sure gas reaches its black start plants during a blackout, because a plant that can start itself still needs something to burn.

What should a household do with this?

Plan for the restoration, since that is the part you will live through.

Power does not come back all at once. It returns in blocks, critical loads first, and it can drop again while operators balance an island. Phone networks need electricity too. A realistic plan covers a day or two with no grid power and no reliable signal.

For me that comes down to two things: a way to charge a phone, and the information I would normally look up online stored somewhere that works without a connection. That is the whole idea behind the kit we sell. If you would rather build your own, the guide is free.

The company is called Blackstart because the name describes the job: getting something working again from nothing.

Questions people ask

What is a black start in simple terms?

It is restarting a power grid after a total blackout. A few plants that can start with no outside electricity come on first, and their power is used to start bigger plants and reconnect customers a section at a time.

How long does a black start take?

Anywhere from hours to weeks. Spain’s transmission grid was back about 16 hours after the April 2025 collapse. The Texas grid operator says a full black start of its region could take multiple days to weeks.

Which power plants can do a black start?

Plants that can start with no power from the grid. Hydroelectric dams are the classic choice, and some large generators are paired with a smaller diesel generator on site that gets them going.

Has Texas ever needed a full black start?

No. In February 2021 the head of the Texas grid operator said the system was seconds and minutes from a collapse that would have required one, and that the resulting blackout could have lasted months.

Sources

  1. Electric Reliability Council of Texas, ERCOT Grid Insights: Black Start, June 20, 2025.
  2. US Department of Energy, Hydropower Plants as Black Start Resources.
  3. POWER Magazine, Anatomy of a Blackout: Findings from the Spain-Portugal Grid Collapse Final Report, March 23, 2026.
  4. The Texas Tribune, via CBS Austin, Texas was ‘seconds and minutes’ away from catastrophic monthslong blackouts, officials say, February 18, 2021.

This post was drafted with AI assistance from the sources listed above and checked against them. If you spot an error, tell us.

Keep reading /

More from the guides

All guides
Be ready

Get your household ready before the next headline.